Gutter Repair Bryan TX homeowners can count on starts with finding where water is actually going. We repair leaking seams, re-pitch sagging runs, replace rusted sections, and reattach gutters torn loose by wind. If your gutters dump water against the foundation or streak your fascia, we fix it before the next hard rain. We serve Bryan, Texas and the surrounding Brazos County area with same-day estimates and code-correct work.
Tell us what is happening. Our local team will confirm your visit shortly.
Call Now (979) 316 9392 → No spam. No obligation. Just practical help.
Gutter repair is the work of restoring a roof drainage system so it moves water away from the house again. That means resealing open seams, replacing rusted or cracked sections, re-pitching runs that have sagged, and reattaching hangers that pulled loose from the fascia board. On seamless systems we cut out the failed piece and splice in a new length of gutter coil matched to the existing profile, so the repair disappears into the run. We also clear clogged downspouts and check that water exits at least 4 feet from the foundation.
In Bryan, gutters take a beating from both directions. Summer heat bakes sealant until it cracks, then a spring storm pushes 2 inches of rain in an hour through a system that was already failing. We see it constantly in older neighborhoods near Downtown Bryan, where original 5-inch gutters are undersized for the roof area they drain. If you have been searching for gutter repair near me Bryan TX and getting nothing but installers trying to sell you a full replacement, we repair what is repairable first.
Every gutter repair job covers the full system check, not just the obvious problem. We look at hangers, pitch, seams, downspouts, and the fascia behind the gutter so the repair actually holds. If we find something outside the repair scope, we tell you before we do the work.
We walk the entire roofline, check every hanger, and test pitch with a level. A moisture meter tells us if the fascia board is wet behind the gutter. You get photos of anything that needs attention.
Failed seams get cleaned, dried, and resealed with gutter sealant rated for Texas heat. Where a section is cracked or rusted through, we cut it out and splice in new gutter coil matched to your existing profile.
Sagging runs get re-pitched at the standard 1/16 inch per foot toward the downspout. We replace failed spike-and-ferrule hangers with screws into solid wood, spaced every 24 inches for a hold that lasts.
We clear every downspout and run water through the system to confirm flow. If discharge lands too close to the foundation, we add extensions to move water 4 to 6 feet away from the house.
When the wood behind the gutter is rotted, the new hanger has nothing to bite into. We replace the damaged fascia board first, then re-hang the gutter so the repair is solid and not just cosmetic.
Old gutter pieces, rotted wood, and debris leave with us. We sweep the ground below the work area and leave you a written summary of what was repaired and what to watch for next season.
You call (979) 316 9392 or book online and tell us what you are seeing: water over the front edge, a gutter hanging down, or a stain on the fascia. We schedule a same-day or next-day visit, usually within a 2-hour arrival window, and text you when the technician is on the way.
We walk the roofline, check every hanger, and run water through the system with a hose. A moisture meter tells us whether the fascia board is wet behind the gutter, and we photograph anything that needs a decision. You get the findings before we touch a tool.
We quote the repair in plain numbers before work starts. Resealing a seam, replacing 10 feet of gutter coil, and re-pitching a run are priced separately so you can see exactly what you are paying for. No surprise line items when the job is done.
Most repairs take 2 to 4 hours. We cut out failed sections, splice in new gutter coil, reseal with gutter sealant, and re-hang the run with screws into solid fascia. If the wood behind the gutter is rotted, we replace that board first so the new hanger has something to bite into.
Before we leave, we run water through the repaired section and watch it exit the downspout. You see the water leave the property. We haul off old gutter pieces, sweep the ground, and leave you a written summary of what was fixed and what to watch for next season.
Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.
Keeps the ladder off the gutter edge so we do not bend the very run we are repairing. It also makes the ladder safer on Bryan's uneven older driveways.
Applies gutter sealant in a controlled bead at seams and corners. A clean bead is the difference between a seal that holds 10 years and one that fails in one summer.
Tells us whether the fascia board behind the gutter is wet. If it reads high, we know to replace the wood before re-hanging the gutter.
Clears debris from the gutter channel and roof surface before we start the repair. A clean channel lets us see the actual damage and test flow properly.
Removes old hangers and lifts gutter sections without crushing the metal. It also helps us pull rotted fascia board cleanly for replacement.
Cuts gutter sealant and trims new gutter coil to length for a clean splice. Sharp cuts mean tighter seams and fewer future leaks.
Required for roof-edge work on steep pitches. Our crews are OSHA 10 and OSHA 30 trained, and we use harnesses on any roof we walk.
A homeowner in Austin's Colony had a back gutter that sagged in the middle and poured water onto the patio every storm. Two hangers had pulled out of the fascia, and the wood behind them was soft. The run had been flat for at least a year.
We replaced 12 feet of rotted fascia board, re-pitched the run at 1/16 inch per foot, and re-hung it with screws spaced every 24 inches. A water test showed full flow to the downspout with no overflow.
A 1940s home in Historic Downtown Bryan had rust streaks down the fascia and peeling paint below the gutter line. The gutter was rusted through in two spots, and water was running behind the channel and soaking the wood.
We cut out 15 feet of rusted gutter, spliced in new gutter coil matched to the original profile, and replaced the wet fascia board. The paint stopped peeling within a month because water was no longer sitting behind the gutter.
After a hail storm in Briarcrest, one gutter run was hanging off the house by a single hanger. Water was running down the exterior wall and into the foundation bed. The homeowner called us the morning after the storm.
We stabilized the run the same day with temporary hangers and tarped the roof edge. Two days later we completed the permanent repair: new hangers, resealed seams, and a full water test. No water entered the house.
Most gutter calls fall into a handful of categories. Here is what we see most often in Bryan and what happens if you let it go.
Ask a pro →We check for clogs first, then test pitch. If the run has sagged, we re-pitch it at 1/16 inch per foot toward the downspout. If the gutter is undersized for the roof area, we tell you straight and quote an upsize.
We pull the run, inspect the fascia for rot, replace any soft wood, and re-hang with screws into solid material spaced every 24 inches. That is a hold that survives Bryan storm season.
We cut out the rusted section and splice in new gutter coil matched to your profile. If the fascia is wet, we replace that board and reseal the gutter so water stays in the channel where it belongs.
We clear the downspout, flush it with a hose, and confirm flow. If the discharge point is too close to the foundation, we add an extension to move water 4 to 6 feet away from the house.
“Our back gutter was pouring water right onto the patio every storm. Bryan Roof Repair Experts came out the same day I called, found two loose hangers and a cracked seam, and had it fixed in about three hours. They ran water through it before they left so I could see it working. Price was exactly what they quoted.”
Marcus T.Homeowner, Austin's Colony
✓ Verified“The gutters on our 1940s house were original and sagging badly. I expected to be told we needed a full replacement. Instead they re-pitched the runs, replaced about 15 feet of gutter coil, and replaced the rotted fascia board behind it. Half the cost of new gutters and they look and work great.”
Sandra K.Homeowner, Historic Downtown Bryan
✓ Verified“After the last hail storm, one gutter run was hanging off the house. They came out, stabilized it the same day, and came back two days later to do the permanent repair once they checked the roof. No water in the house, no drama. I have already recommended them to two neighbors.”
Dale R.Homeowner, Briarcrest
✓ VerifiedMost gutter repairs in Bryan run $180 to $650 in 2026, depending on how many sections are failing. Resealing a single seam is on the low end. Replacing 20 feet of gutter coil, re-pitching a run, and replacing rotted fascia board pushes toward the higher end. We quote the exact price before work starts, so you are never guessing.
Yes. We repair gutters throughout Bryan, Texas, including 77801, 77802, 77803, 77807, and 77808. Our crews handle leaking seams, sagging runs, loose hangers, rusted sections, and clogged downspouts. We work on seamless aluminum, steel, and the older gutter profiles found in Historic Downtown Bryan and the East Side Historical District.
Four signs mean it is time to call: water pouring over the front edge during rain, gutters pulling away from the fascia, rust streaks or peeling paint below the gutter line, and standing water at the foundation. In Bryan, the first sign usually shows up after a heavy spring storm. If you see any of them, a repair now is cheaper than fascia replacement later.
Bryan Roof Repair Experts repairs gutters in Bryan, TX and the surrounding Brazos County area. We are a local crew with HAAG Certified Inspector training and OSHA 10 and OSHA 30 certifications. Call (979) 316 9392 for a same-day estimate. We repair what is repairable and tell you straight if replacement makes more sense.
Roof RepairGutter problems often start at the roof edge. We repair damaged shingles, flashing, and drip edge so water reaches the gutter instead of running behind it.Explore →
Roof Leak RepairA leak at the roof edge and a failing gutter look the same from the ground. We trace the water source and fix the actual entry point, not just the symptom.Explore →
Shingle Roof RepairLoose or missing shingles at the eave dump water past the gutter. We replace damaged shingles and reset the drip edge so the gutter catches what it should.Explore →
Metal Roof RepairMetal roofs shed water fast, which overloads undersized gutters. We repair the roof panels and upsize the gutter run if needed to handle the volume.Explore →
Flat Roof RepairFlat and low-slope roofs need proper drainage before gutters matter. We repair ponding issues and confirm water reaches the gutter system efficiently.Explore →
Tile Roof RepairBroken tile at the eave sends debris into the gutter and causes clogs. We repair the tile and clear the gutter so water flows freely again.Explore →
Emergency Roof RepairWhen a storm tears a gutter loose and water is entering the house, we tarp and stabilize the same day, then return for permanent gutter repair.Explore →
Storm Damage Roof RepairHail and wind bend gutters and rip hangers out of the fascia. We document the damage, repair the roof, and restore the gutter system to working order.Explore →Water over the edge today means fascia rot tomorrow. Call (979) 316 9392 and we will get an estimator to your Bryan property, usually the same day. Licensed, insured, and we quote the price before we start.
Book My Estimate (979) 316 9392 →Call us at (979) 316 9392 and you get a real person who can schedule your inspection, not a call center. We answer Monday through Friday from 8:00 to 18:00, and we run 24/7 for emergency roof repair in Bryan. Leave a message after hours and we call back first thing.